Low-to-high voltage “step-up” or “boost” DC-DC industrial converters scale low voltage 12Vdc batteries to a higher DC-output voltage
LTH-65-F3-HSA series low-to-high heavy-duty industrial DC-DC converters deliver up to 250W with convection cooling
The LTH 65-F3-HSA series of heavy-duty, industrial quality step-up (boost) DC-DC converters operate from a 12Vdc (10.5-16V) input and deliver 24Vdc, 48Vdc or 125Vdc with their corresponding float voltages. An optional built-in redundancy diode allows for paralleling and N+1 operation or back-up battery connection. An output fail alarm is also available on request.
The converters are designed to float charge hold-up batteries for electrical equipment installed in transportation and industrial applications.
The converters are convection cooled via a heatsink assembly block with fins attached to the under-surface of the unit. Additional cooling is achieved by natural convection through the cooling slots. This mechanical structure allows for applications where a heatsinking surface is not available. The heatsink assembly also allows for mounting on uneven and thermally non-conductive surfaces, such as wood, plastic and brick walls.
The units are rated for operation over a 0°C to +50°C temperature range for full specification with no derating required; wider temperature ranges are available on request.
HSA-F3 heatsink assembly with fins enable convection cooling. This mechanical structure allows the unit to be mounted on uneven and thermally non-conductive surfaces. No fans or installation on a heat-sinking surface required. (Click on image for mechanical outline drawing)
The converters are designed for compliance with EN62368-1 and equivalent safety standards. Electronic protection includes 1000Vdc input-output isolation, inrush current limiting, reverse polarity, over voltage, over temperature and short circuit conditions. The input and output are filtered for low noise. The input meets EN55032 Class A with wide margins.
ABSOPULSE Electronics is an original equipment manufacturer (OEM). We design and manufacture an extensive range of custom power conversion solutions in-house.
For further information on this converter or any of your power conversion requirements, please contact us.
Key Specifications
- Input: 12Vdc (10.5-16V);
- Output: 24V, 48V or 125Vdc and corresponding float voltages;
- -0°C to +50°C operating temperature range – no derating;
- Designed in compliance with EN62368-1 and corresponding safety standards;
- EMI: EN55032 Class A with margins;
- Ruggedizing – withstand shock and vibration (IEC 61373 Cat 1 A&B);
- Conformal coating – protection from humidity and airborne contaminants;
- Efficiency: typically 80% at full load;
- Full electronic protection;
- Heatsink assembly attached to F3 chassis (HSA-F3):
132mm x 102mm x 323 mm (5.2″ x 4″ x 12.7″) W x H x L.
Data sheet – LTH 65-F3-HSA, 250W, industrial DC-DC converters
Copyright © ABSOPULSE Electronics Ltd
